• Universal application.  Non-handed for standard, top-jamb or parallel arm installation
• Non-sized, 1 thru 6 FACTORY PRESET SIZE 3 meets ADA.
• Standard adjustable back-check function
• Adjustable closing and latching speed by two separate regulating valves
• Optional adjustable delayed action (DA)
  Preset at the factory for approximately 20 seconds, between 70° and 0°
  Delay time easily adjusted up to 1 minute. CR4041 DA
• Standard full plastic cover

• Parallel hold-open adjustable arm (Non handed).  CR3049HO
• Non-handed forged solid steel parallel arm for extra abusive installations. CR3077HDAR
• Optional, non-handed parallel arm features solid forged steel main arm and forearm with stop in soffit shoe.  CR3077SPAS
• Optional, non-handed parallel arm features solid forged steel main arm and forearm provides hold-open function with templated stop/hold-open points.  Handle controls hold-open function.  CR3049HOSRPS
• Drop plate used where top rail is less than 3-3/4".  CR18

• Drop plate for top jamb where face is less than 3-1/2".  CR18TJ

• Drop plate for top jamb mounted closer flush with top of head frame face in flush ceiling condition.  Plate requires 1-3/4" minimum head frame.  CR18G

• Drop plate for parallel arm mounting top rail is less than 5-12" measured from stop.  Plate requires 2" minimum top rail.  CR18PA

• Available in ALUM, DURO, Gold, US3, 26 and other plated finishes.

• Optional metal cover.

IMPORTANT   Any door closer, including those certified by BHMA to conform to ANSI Standard A156.4, that is chosen, installed and adjusted based on ADA or other reduced opening force requirement may not provide sufficient power to close and latch a door.  Location of door could also affect action and efficiency of door closer.

EXTERIOR (and VESTIBULE) DOOR WIDTH

INTERIOR DOOR WIDTH